If you encounter the vibration from gear reduction motor? Please continue to read as VEER Motor.
- Whether Speed Reducer (Gearbox) Matches Electric Motor?
The gear reduction motor has both speed index and torque index, the rotate speed and torque are different even the powers of gear reduction motor are same, so as long as the gear motor is adopted by hard connection, there should be considered two indexes (rotate speed and torque). If the torque doesn’t meet the need torque from gear motor that the motor will vibrate or not rotate. Of course, in many times, in cases of rotate speed from high to low, the speed reducer (gearbox) can still running, but there is a defect, if gear motor is running for a long time, which will overload.
- Whether Gear Reduction Motor is overloaded or not?
In general situation, the gear reduction motor is used with other devices during running, the overloads are the needed, and each transmission equipment has their limit load index. So, the limit load index of gear motor should consider all members in whole, and environmental factor, etc. So, load determination is also an important factor to analyze vibration faults.
- Whether the attached base for gear reduction motor can be met the requirement?
Electric motor and speed reducer (gearbox) are the heavy devices, which must depend on basic force of attaching base to meet the stress generated during gear motor running, therefore, the weight of attaching base is more important. The heavy attaching base will eliminate vibrations during gear motor running. So just keep the attaching base is heavy.
- Whether the gear reduction motor is installed properly?
The vibration directions are from radial and axial, which also are named radial beat and axial beat, particularly, two devices are connected by hard, no matter which one occurs beat on the connecting shaft, also it will increase the beat on the whole device. Although the shaft coupling will improve the defect, but once beyond the scope of shaft coupling can be eliminated, it still cannot solve the vibration problem of gear reduction motor.
- Power Supply Factor
Due to the large number of enterprises using variable frequency and voltage technology, so there have bad waves in power system. When the gear reduction motor runs with loads under the power insufficient or disorganized, which will cause the gear motor running in the semi-linkage state, and then cause the vibration of gear motor, in the end, will cause the whole transmission devices with vibration.
Above all, the vibration of gear reduction motor is not an independent fault, but a comprehensive fault, which causes a great harm, and even will cause the system damage, paralysis, and up to endanger personnel safety, so it must be taken seriously. Please contact VEER Motor when you need to help, email to: firstname.lastname@example.org, or visit our official website: https://www.veermotor.com/